Dental Lab Flexible Denture Machine Dentistry

Features:

Flexible Denture Machine is the equipment which specializes in flexible false tooth, designed and produced by our company at the first time. It is the crystal of many years clinic experience. It featured simple and credible operation, long service life,high quality, high success rate and so on.

Main technical parameter and environmental condition

• Rating Voltage: 220V/110V  50HZ±1HZ
• Power: 450W
• Temperature: 260℃-310℃
• Available working hour modulation: 9 ~13 minutes
• Environmental temperature: -5℃-45℃
• Environmental comparatively humidity: ≤90%
• Surroundings should have no eroded gas.

Size and weight

• Die-casting machine package size: 65cm X 36cm X 35cm
• Heating furnace package size: 57cm X 38cm X 30c
• Package Weight: Heating machine: 16.5KG         Pressure machine:23.5KG

Installation and debugging

• The die-casting machine is fixed on worktable (or cement table) with 4pcs bolts. The height of the table should convenient to operation.
• The heating furnace is laid next to die-casting machine, the distance between the two machine should be more closer on the basis of heating furnace not impacting die-casting machine operation.
• Before debugging, the temperature on the temperature controller should be adjusted to 287℃ and the time on the time controller should be adjusted to 11 minutes.
• To connect the power and turn on the power switch , startup time controller switch ,when the device give an alarm in the pre-set time and the fluctuation of the temperature is not exceed 10℃ after counterpoised , it proved that you bought a qualified flexible denture machine.

Operation process

• Before operating the machine, you should screw down the nut of the spring on two stand poles of die-casting machine and lay the prepared flask on the machine.
• At first, using hair brush smear the inner intake tube with isolation oil, and then insert it in heating furnace, Please set the temperature as 287 ℃ and time as 11 minutes.
• To connect the heating furnace power, preheating at least 20 minutes. When preheating, it is normal that the temperature exceed the pr-set temperature (287℃), need not adjust.
• When the temperature turn to stable (it is normal if there is 10℃ error between displayed temperature and pre-set temperature), use hair brush smear the empty   aluminium cartridge and copper cushion surface with isolation oil, then put the cartridge into intake tube, and then put the false tooth materials into cartridge (beaded edge inby), and then put the copper cushion (middle cartridge with one thick copper cushion and small cartridge with both thick and thin copper cushion per each).
• After the false tooth materials put into heating furnace, turn on time controller switch. The buzzer will alarm after heating 11 minutes, then take out the intake tube and put it on flask to compress. After compress 2 minutes, the intake tube can be unbolted.

Safeguard protection device and notice

• This machine is fixed with earth protection device. Notice: the earth power should be used when operate this machine.
• After compressed the materials, you can use compression machine to pack out the materials remains in the intake tube. If it difficult, you can heat a little and operate again.

Packing list